Thatching Roof Installation

Overlap each panel roughly seven to eight inches on center for a full appearance.

Thatching roof installation.

Tie the four corner boards together by nailing in cross members extending from each corner parallel to the ridge pole and 24 inches apart. Start by measuring the surface and cutting the thatch rolls to the desired length. Thatching included as one of the crafting activities for the roofing process. Then attach the base of the thatch panel or roll using a staple gun with at least staples.

Step 1 build the roof structure for the thatching by nailing a 2 by 4 inch piece of lumber from each of the four corners of the building up to a center ridge pole that runs parallel to the ground. Real thatching is done on a house without a sub roof and at a pitch of at least 45 degrees. Build with dry vegetation materials including water reed heather straw rushes and also palm branches. The thatch is laid directly on the rafters and is visible from the inside of the structure.

Starting at the bottom edge of the roof attach each panel to the roof with a staple gun or a hammer. Laying thatch on a roof or walls requires you to be layer the thatch by stapling the panels so that they overlap. Tiki thatch installation for flat roofs or walls.